Clinical

Fluid therapy calculation for dogs and cats, with examples

How to calculate fluid therapy for dogs and cats: maintenance rate, dehydration deficit, ongoing losses, ml per hour and drops per minute, with worked examples.

Quick answer: A fluid plan for a dog or cat adds three parts: maintenance (132 × kg^0.75 ml/day for dogs or 80 × kg^0.75 for cats, or about 2 ml/kg/h as a rule of thumb), the deficit (kg × % dehydration × 10 ml) spread over the hours the vet chooses, and ongoing losses. Divide by 24 for ml/h; drops/min = ml/h × drops per ml ÷ 60.

By Radiatus team · Published 04 Nov 2026 · Updated 04 Nov 2026 · 12 min read

Written for your clinic's veterinarian to review and adapt. Last reviewed: 4 November 2026. The formulas and calculator below are reference arithmetic; they support, and never replace, the veterinarian's judgement, and the vet confirms every fluid plan and rate for each patient.

For fluid therapy in dogs, the calculation comes down to three numbers added together and then converted into something you can set on a drip: maintenance, deficit and ongoing losses, turned into millilitres per hour and drops per minute. The same method works for cats with a different maintenance constant. This guide explains each part, gives three worked examples and a drip-rate table for the 20 and 60 drops/ml gravity sets common in Indian clinics, and lists the mistakes that cause most errors.

Total rate59.2ml/h
Drip rate19.7 drops/min
One drop every3 s
Maintenance537.6 ml/day
Deficit784 ml

Reference only. Starter values (2 ml/kg/h; 132 or 80 × kg^0.75 ml/day) are editable. The calculator supports, and never replaces, the veterinarian's judgement: the vet confirms every fluid plan and rate.

Change the weight, method, dehydration, hours, losses and drip set; the rate, drops per minute and seconds per drop update as you type. The defaults are Milo's numbers from the first worked example below.

The three parts of a fluid plan

Maintenance is the water an animal needs each day to replace normal losses through urine, faeces, breathing and skin. Deficit is the water it has already lost, estimated from its hydration status. Ongoing losses are the extra losses still happening, from vomiting, diarrhoea, polyuria, drains or wounds. A fluid plan adds maintenance to the deficit (replaced over a chosen number of hours) and to the losses, then sets a rate. The vet reassesses the patient often and changes the plan; the numbers are a starting point, not a fixed prescription.

How to calculate maintenance fluid rate for a dog

ml/kg/h method

The simplest approach is a linear rule of thumb of about 2 ml/kg/h, which many clinics teach as roughly 40–60 ml/kg/day. It is quick to work out at the cage: a 10 kg dog gets about 20 ml/h. Its weakness is that linear formulas overestimate needs for large dogs and underestimate them for very small ones, because water needs track metabolic rate rather than body weight.

Metabolic (kg0.75) method

The allometric formula published in the 2013 AAHA/AAFP Fluid Therapy Guidelines for Dogs and Cats scales with metabolic body weight: dogs 132 × body weight (kg)0.75 ml per day. For an 11.2 kg dog, 11.20.75 is about 6.12, so maintenance is 132 × 6.12 ≈ 808 ml/day, or 33.7 ml/h. Any phone calculator with a power key (xy) does this; the calculator above does it for you.

Cats

The same guidelines give 80 × body weight (kg)0.75 ml per day for cats. Cats are generally more sensitive to fluid overload than dogs, so the vet watches respiratory rate and effort, weight gain and chemosis closely, and many clinics use a microdrip set or a burette for cats and small dogs.

Which method to use is the vet's choice. Pet Clinic Software's calculator offers both, with the linear 2 ml/kg/h and the 132 / 80 constants as editable starter values.

How to calculate dehydration deficit

The deficit in millilitres is body weight (kg) × % dehydration × 10 (the same as kg × the fraction dehydrated × 1,000). A 20 kg dog estimated at 6 % dehydrated has a deficit of 20 × 6 × 10 = 1,200 ml. The vet decides how quickly to replace it, often over about 12 to 24 hours in a stable patient, and faster or slower depending on the case. Estimating the percentage is the least precise step, so use it with the patient's history, PCV and total protein, and weigh the animal again to see whether the estimate was right.

Estimated dehydrationTypical clinical findings (reference only)
Under 5 %History of fluid loss, no detectable changes on examination
About 5–6 %Subtle loss of skin elasticity, slightly tacky mucous membranes
About 6–8 %Delayed skin tent, dry mucous membranes, possibly slightly prolonged capillary refill
About 10–12 %Skin stays tented, sunken eyes, prolonged capillary refill, possible signs of shock
Over 12 %Signs of hypovolaemic shock; an emergency that needs the vet's immediate plan

Clinical estimates of dehydration are imprecise; age, body condition and skin type change the signs. Shock is treated differently from dehydration and is outside the scope of this guide.

Adding ongoing losses

Estimate the extra volume lost each day and add it. Measure where you can: weigh soiled bedding (1 g ≈ 1 ml), measure vomit or drain output, and track urine. If you cannot measure, a common practical approach is to estimate the volume of each episode of vomiting or diarrhoea and total it over the day, then adjust after re-weighing. Losses change quickly, so the vet revisits this number at each check.

Converting ml per hour to drops per minute

Without an infusion pump, the rate is set by counting drops in the drip chamber. The giving set's packet states its drop factor: macro sets are commonly 20 drops/ml (some are 10 or 15), and micro or paediatric sets are 60 drops/ml.

Drops per minute = ml/h × drops per ml ÷ 60. On a 60 drops/ml set, drops per minute equals ml/h, which is why microdrip sets are easier for small patients. Seconds per drop = 3,600 ÷ (ml/h × drops per ml).

Rate (ml/h)20 drops/ml set (drops/min)60 drops/ml set (drops/min)
103.310
206.720
3010.030
4013.340
5016.750
6020.060
8026.780
10033.3100
12040.0120
15050.0150

Count drops for a full 15 seconds and multiply by four, rather than guessing from a few seconds. Recheck the rate after the patient moves, because limb position changes the flow on a gravity set.

Worked example 1: Milo, 11.2 kg, 7 % dehydrated

Sample data (illustrative). Milo is an 11.2 kg Beagle with gastroenteritis, estimated 7 % dehydrated, with about 100 ml/day of ongoing losses. The vet chooses the linear method at 2 ml/kg/h, replaces the deficit over 24 hours, and the clinic uses a 20 drops/ml set.

  • Maintenance: 11.2 × 2 = 22.4 ml/h
  • Deficit: 11.2 × 7 × 10 = 784 ml, ÷ 24 = 32.67 ml/h
  • Losses: 100 ÷ 24 = 4.17 ml/h
  • Total: 22.4 + 32.67 + 4.17 = 59.23 ml/h, so about 59 ml/h
  • Drops: 59.23 × 20 ÷ 60 = 19.7, so about 20 drops per minute, one drop roughly every 3 seconds

For comparison, the allometric maintenance for Milo is 132 × 11.20.75 ≈ 808 ml/day, or 33.7 ml/h, which gives a total of about 70.5 ml/h (23.5 drops/min on the same set). The two methods differ; the vet chooses and then adjusts after reassessment and re-weighing.

Worked example 2: a 4 kg cat on maintenance fluids

Sample data (illustrative). A 4 kg cat, not dehydrated and with no ongoing losses, needs maintenance only. By the allometric formula: 40.75 ≈ 2.83, and 80 × 2.83 ≈ 226 ml/day, or 9.4 ml/h. On a 60 drops/ml microdrip set that is about 9 drops per minute, one drop roughly every 6–7 seconds. If the cat is going under anaesthesia, the vet sets the intra-operative rate for that patient; record it on the anaesthesia sheet rather than reusing the maintenance figure by habit.

Worked example 3: a 30 kg dog with vomiting

Sample data (illustrative). A 30 kg Labrador, estimated 5 % dehydrated, still vomiting about 300 ml a day. The vet uses 2 ml/kg/h, replaces the deficit over 24 hours, on a 20 drops/ml set.

  • Maintenance: 30 × 2 = 60 ml/h
  • Deficit: 30 × 5 × 10 = 1,500 ml, ÷ 24 = 62.5 ml/h
  • Losses: 300 ÷ 24 = 12.5 ml/h
  • Total: 135 ml/h, which is 135 × 20 ÷ 60 = 45 drops per minute, about one drop every 1.3 seconds

At this size the allometric maintenance (132 × 300.75 ≈ 1,692 ml/day, 70.5 ml/h) is close to the linear figure. At 45 drops per minute, counting is hard; a pump or a burette makes the rate more reliable.

Monitoring a patient on fluids

A fluid plan is only as good as its monitoring. Record the volume actually given each hour, check the catheter site and line, weigh the patient at least twice a day (a 1 kg change is about a litre of fluid), and watch urine output, respiratory rate and effort, mucous membranes and attitude. Print a chart like this for each patient, or use a digital treatment sheet.

TimeFluid and rate (ml/h)Volume this hour (ml)Running total (ml)Line / site OKUrineNotesInitials
08:00
09:00
10:00
11:00
12:00

For a full 24-hour paper sheet with drug, fluid and observation rows, print the free veterinary treatment sheet.

Common calculation mistakes

  • Mixing ml/kg/day and ml/kg/h. 60 ml/kg/day is 2.5 ml/kg/h, not 60 ml/h.
  • Forgetting ongoing losses, so a vomiting dog stays dehydrated despite a "correct" plan.
  • Using the wrong drop factor. The same 60 ml/h is 20 drops/min on a 20 drops/ml set but 60 on a microdrip set: a threefold error.
  • Not re-weighing. Weight is the best check on whether the deficit estimate and rate were right.
  • Using an old weight. Calculate from today's weight, as for drug doses; our veterinary dose calculator by weight uses the same principle.
  • Leaving the rate unchanged. Once the deficit is replaced, the rate should fall to maintenance plus losses, on the vet's instruction.

Fluid orders on the Pet Clinic Software treatment sheet

In Pet Clinic Software the same calculator is built into the fluid order on the hourly veterinary treatment sheet: enter weight, method, dehydration, hours, losses and drip set, press "Use this rate", and the order carries fluid type, ml/h, drip set and drops per minute. Continuous fluids get an hourly "check fluids" task where the nurse records the millilitres given and whether the line is OK; missed checks turn red on the ward view, and the shift handover lists the running rate for each patient. The starter values are editable in Hospital settings. There is no infusion-pump integration; rates are set and checked by staff. Treatment sheets are part of the Hospital module with the hospital whiteboard and the anaesthesia monitoring sheet, in the Hospital plan at ₹2,999 a month; see plans and prices. Put fluid orders on an hourly treatment sheet: start a free trial (Hospital plan).

Questions people ask

What is the maintenance fluid rate for a dog in ml/kg/hr?

A common rule of thumb is about 2 ml/kg/h. The 2013 AAHA/AAFP fluid therapy guidelines give an allometric formula of 132 × body weight (kg) to the power 0.75 ml per day for dogs, which suits very small and very large dogs better. The vet chooses the method; Pet Clinic Software's calculator offers both.

How do you calculate the percentage of dehydration in a dog?

It is estimated clinically from skin tent, mucous membranes, eye position, capillary refill and history, supported by PCV, total protein and weight change. Under 5 % is usually undetectable; 6–8 % shows a delayed skin tent and dry gums; above 10 % brings sunken eyes and shock signs. Estimates are imprecise, so re-weigh.

How do you convert ml per hour to drops per minute?

Multiply ml/h by the drop factor of the giving set and divide by 60. At 60 ml/h on a 20 drops/ml set that is 60 × 20 ÷ 60 = 20 drops per minute; on a 60 drops/ml set drops per minute equals ml/h. Count drops for 15 seconds and multiply by four.

What is the difference between a 20-drop and a 60-drop set?

A 20 drops/ml (macro) set delivers one millilitre in 20 drops; a 60 drops/ml (micro or paediatric) set needs 60 drops for the same millilitre, so each drop is smaller. Microdrip sets make slow rates easier to count for cats and small dogs. The drop factor is printed on the packet.

How is fluid therapy for cats different from dogs?

The allometric maintenance constant is lower, 80 × kg^0.75 ml per day instead of 132, and cats are more prone to fluid overload, so vets monitor respiratory rate and effort, weight and chemosis closely and often use microdrip sets or pumps. The deficit and drip-rate formulas are the same.

Over how many hours should a dehydration deficit be replaced?

The vet decides for each patient. In stable patients the deficit is often replaced over about 12 to 24 hours, faster when needed and slower in animals at risk of overload, such as those with heart disease. Reassess and re-weigh during replacement, and drop to maintenance plus losses once it is done.

Related guides

Every pet on record. Every vaccine on time.

Import your owner list in an afternoon. 14-day free trial, no card, free migration from paper, Excel or any other software.